Table of Contents
Advertisement
5019_719_01120_GB_STEP_FILO:Layout 1
Induction zone functions
This hob is fitted with 2 induction zones that allow
you to boil water very quickly, as well as control
the temperature with extreme precision, giving you
a vast range of cooking options. The induction
zone control panel has the following functions.
1. On/off touch pad control
2. Child safety lock
3. Zone selection/ power level adjustment
4. Timer switch
5. LED display
6. LED indicator
7. Induction zone indicator symbol
IMPORTANT
Use pans made of a material suitable for
induction cooking. See the chapter on
"Precautions and general recommendations"
on page 9.
To use the induction zones on your hob press
button (1) for 2 seconds. The two displays (5) will
show the number 0. If the induction zone is not
selected within 10 seconds the zone will
automatically switch itself off for safety purposes.
Select the zone you wish to use by pressing one of
the buttons (3). If you press the + button, the
zone selected will automatically switch on with the
power set at 5. If, however you press the - button
the zone is automatically switched on with the
power level set at 10. The power level can then be
adjusted up or down from 1 to 10 using the
buttons (3) as required. Pressing the + and -
buttons simultaneously turns off the induction
zone.
19-07-2007
14:03
Pagina 6
The child safety option can be turned on by
pressing the button (2) until the illuminated point
above the button with the key symbol (2) comes
on. This option blocks all the buttons with the
exception of the on/off button (1). The option will
stay on even after the cooktop has been turned off
and on again and can be disabled by pressing the
button (2) again until the light above the button
disappears.
Should there be a power cut or a failure in the
distribution network, the option will turn off.
The timer switch option can be used both as a
timer and to programme how long each zone will
stay on for. In order to programme a zone using
the timer option, just select the zone using the +/-
buttons (3) and the power level required. Activate
the timer option by pressing the button with the
clock symbol (4) located to the side of each display.
LED (6) showing the selected zone will flash above
the selected zone's display. The display will show
00. Set the required cooking time (1 min to 99
mins) within 10 seconds using the +/- buttons (3).
After 10 seconds the timer option start
automatically and the red control light (6) will stay
on, whilst the display will show the power setting.
Alternatively if the 10 seconds have not elapsed
start the timer by pressing the clock symbol button
(4) again. Once you have programmed the timer,
you can change the power level selected using the
+/- buttons (3). Pressing the clock symbol button
will show the time remaining.
6
Advertisement
Table of Contents
