Table of Contents
Advertisement
B. Good Faith Wall Surface
SURROUND
OPENING
151 ºF
Figure 2.4 Good Faith Wall Surface Temperatures Above Appliance
If installing a television (TV) above the appliance, see
Section 3 of the appliance Owner's Manual.
NOTICE: Temperatures listed above are taken with a
temperature measuring probe as prescribed by the test
standard used for appliance certification. Temperatures
on walls or mantels taken with an infrared thermometer
may yield increased temperatures of up to 30 ºF or more
depending on the thermometer settings and material
characteristics being measured. Use appropriate finishing
materials that are able to withstand these conditions. For
additional finishing guidelines, see Section 8.
C. Tools and Supplies Needed
Before beginning the installation be sure that the following
tools and building supplies are available.
Tape measure
Pliers
Hammer
Phillips screwdriver
Voltmeter
Electric drill and bits (1/4 in.)
Gloves
Safety glasses
Level
Reciprocating saw
Manometer
Flat blade screwdriver
Stove cement / Aluminum foil tape
3/16 in. Allen wrench (Rear Leveling Legs)
Elongated pressure taps (Recommended)
Noncorrosive leak check solution
Caulking material (300 ºF minimum continuous exposure
rating)
Heat & Glo • COSMO-I30-IFT, COSMO-I35-IFT Installation Manual • 2535-980 Rev. V • 10/23
108 ºF
110 ºF
115 ºF
46 IN.
120 ºF
40 IN.
125 ºF
34 IN.
127 ºF
28 IN.
135 ºF
24 IN.
138 ºF
22 IN.
18 IN.
16 IN.
12 IN.
MEASUREMENTS FROM TOP
OF THE SURROUND OPENING
APPLIANCE SURROUND
D. Inspect Appliance and Components
• Carefully remove the appliance and components from
CEILING
the packaging.
106 ºF
• The vent system components, decorative barrier fronts
and surrounds are shipped in separate packages.
52 IN.
• Glass media must be installed to ensure proper
performance. See your dealer for details.
• Report to your dealer any parts damaged in shipment,
particularly the condition of the glass.
• Read all of the instructions before starting the instal-
lation. Follow these instructions carefully during the
installation to ensure maximum safety and benefit.
WARNING! Risk of Fire or Explosion! Damaged parts
could impair safe operation. DO NOT install damaged, in-
complete or substitute components. Keep appliance dry.
Hearth & Home Technologies disclaims any responsibility for,
and the warranty will be voided by, the following actions:
• Installation and use of any damaged appliance or vent
system component.
• Modification of the appliance or vent system.
• Installation other than as instructed by Hearth & Home
Technologies.
• Improper positioning of the gas logs or the glass door.
• Installation and/or use of any component part not approved
by Hearth & Home Technologies.
Any such action may cause a fire hazard.
WARNING! Risk of Fire, Explosion or Electric Shock!
DO NOT use this appliance if any part has been under
water. Call a qualified service technician to inspect the
appliance and to replace any part of the control system
and/or gas control which has been under water.
7
Advertisement
Table of Contents
