Table of Contents
Advertisement
P. Replacing the PC Board
CAUTION: Unplug the vacuum cleaner before servicing.
1. Turn the machine over and remove the two screws holding the nozzle cover (Fig. A.)
2. Flip the machine back over and remove the cover as shown in Fig. B.
3. Remove the (2) screws holding the PC board (Fig. C.)
4. Disconnect the PC Board wires by squeezing the crimps with needle nose pliers (Fig. D.)
5. Install the new board using the screws.
6. Rewire the new PC board (See wiring diagram, pg. 35)
Fig. A
Fig. C
II. Maintenance
Fig. B
Fig. D
Page 28
Advertisement
Table of Contents
