Maintenance And Care; Replacing The Vacuum Bag - Maytag M600 Owner's Manual

Replacing the Vacuum Bag

NOTE: Turn the vacuum off and unplug
the charger from the Charge Point before
changing the bag.
• Unzip the bag compartment.
• Remove the used vacuum bag by pulling
the green bag collar tab away from the
vacuum (Fig. 1). Slide the used bag out of
the bag holder, which automatically seals
the bag opening (Fig. 2). Discard the
used bag.
• To install a new bag, slide the bottom of
the green bag collar into the bag holder
until it snaps into place (Fig. 3).
• Push the top of the bag collar upward
until the collar snaps into place on
the vacuum (Fig. 4).
• Tuck the bag corners into the bag
compartment then zip the bag
compartment closed.

MAINTENANCE AND CARE

MATERIAL
DRAWN
ISSUED
SCALE
1.000
6
MATERIAL
DRAWN
ISSUED
SCALE
1.000
6
9
Fig. 1
Fig. 2
FINISH
DATE
TACONY CORPORATION CLAIMS PROPRIETARY
RIGHTS IN THE MATERIAL DISCLOSED HERE IN.
DATE THIS DRAWING IS ISSUED FOR ENGINEERING
.02 IN RADII X.X ± .02
INFORMATION ONLY. IT MAY NOT BE REPRO-
.01 IN X,XX ± .01
DUCED, NOR MAY THE INFORMATION HERE IN
.005 IN MACHINE SURFACE
BE USED FOR MANUFACTURING PURPOSES
.0005 IN BREAK SHARP CORNERS TO .010 MAX
WITHOUT WRITTEN PERMISSION FROM TACONY
0 ° 30" COMMON TO BE CONCETRIC TO .002
CORPORATION.
7
Fig. 3
FINISH
DATE
TACONY CORPORATION CLAIMS PROPRIETARY
RIGHTS IN THE MATERIAL DISCLOSED HERE IN.
DATE
THIS DRAWING IS ISSUED FOR ENGINEERING
.02 IN RADII X.X ± .02
INFORMATION ONLY. IT MAY NOT BE REPRO-
.01 IN X,XX ± .01
DUCED, NOR MAY THE INFORMATION HERE IN
.005 IN MACHINE SURFACE
BE USED FOR MANUFACTURING PURPOSES
.0005 IN BREAK SHARP CORNERS TO .010 MAX
WITHOUT WRITTEN PERMISSION FROM TACONY
0 ° 30" COMMON TO BE CONCETRIC TO .002
CORPORATION.
7
Fig. 4
DESCRIPTION
DRAWING SIZE
PART NUMBER
SHEET 1 O
8
DESCRIPTION
DRAWING SIZE
PART NUMBER
SHEET 1 O
8