Table of Contents
Advertisement
D. Replacing the Agitator
CAUTION: Unplug the vacuum cleaner before servicing
1. Remove the baseplate by turning the screws to the left as shown in Fig. A.
2. Remove the agitator by pulling it outward.
3. Loop belt around the new agitator pulley. Make sure the belt is around the motor shaft and is not
twisted. If the belt falls off of the motor shaft it may be necessary to remove the nozzle cover to
reinstall the belt. See page 17, II. Maintenance, H. Removing Nozzle Cover
4. Roll agitator into place. Position end caps as shown in Fig. B.
Fig. A
II. Maintenance
Fig. B
Page 13
Advertisement
Table of Contents
