2.4.3. Connections for Outdoor Operation
For Remote/Outdoor tuner operation, the grounding terminal of the tuner labeled
GROUND (see
Figure 2-9 | Tuner bottom view with connectors
should be connected as described in Section
installed outdoor
After completing the tuner installation, attaching, and connecting the cables, check the
reliability of all fixtures and fasten again, if necessary. Apply mineral jelly or another
suitable lubricant to the connectors, grounding terminal, and assembling nuts and screws
to prevent jamming/clinching or damage to the threads in a future disassembly.
To avoid any damage (not covered by the warranty), never connect or disconnect cables
while power is applied at either end of the cable.
Hot-plugging is technically incorrect and is a bad practice to connect or disconnect any
piece of equipment while it is powered on. Make sure the device is switched off before
connecting or disconnecting any cable.
Page 34 of 88 | S e c t i o n INSTALLATION
User's Manual | ACOM 04AT | Remote Automatic Antenna Tuner and Switch
.
Figure 2-9 | Tuner bottom view with connectors
Figure 2-9 | Tuner bottom view with connectors
NOTICE
DANGER
) and the antenna feeders
1.9.2 Lightning protection when the tuner is
DANGER
3
October 2023