User's Manual | ACOM 04AT | Remote Automatic Antenna Tuner and Switch
If the tuner will be mast or wall mounted, the weather protective cover (see Pos. 2) will be reassembled after
mounting the selected mast or wall bracket.
After dismounting, the weather cover (Pos. 2) and mounting brackets (Pos. 4) should be safely stored.
with ACOM 04-WP weather protection cover removed, and without installation accessories
2.3. Power Supply Voltage
The tuner is powered by direct-current voltage +26 VDC +10/-15%, supplied through the coaxial cable from
the ACOM amplifier RF OUTPUT to the RF input of the tuner, labeled 50Ω RF +26 VDC POWER & CONTROL.
To avoid any damage (not covered by the warranty), never connect the input jack of the
tuner, labeled 50Ω RF +26 VDC POWER & CONTROL to any power source except the
output of an amplifier from the ACOM transistor series.
October 2023
Figure 2-4 | ACOM 04AT tuner
Figure 2-4 | ACOM 04AT tuner
NOTICE
S e c t i o n INSTALLATION | Page 27 of 88
2
5