Operation; Function Operate And Auto Tune Procedure - Acom 03AT Operating Manual

Fig.3-1 ACOM 03AT Remote Control Unit (RCU).
BYPASS [OPERATE]
STATUS SWR-CHK
On the menu are shown the four main functions that are available – BYPASS, OPERATE, STATUS, and SWR-CHK
(SWR check).
The function OPERATE is shown selected between square brackets in the example above. If you wish to select
another function, move the brackets in the required direction with the < (left) and > (right) arrow buttons, so that they
enclose the desired item. The selected function would be activated if you press the button Enter. When the edge of
the display is reached, future movement in the same direction will cause the brackets to scroll to the opposite row of
the display. After that, you can move the brackets to the left or to the right using the corresponding arrow button.
For instance, press the button < (left) to select the function BYPASS:
[BYPASS] OPERATE
STATUS SWR-CHK
To exit from an item, press the Esc (Escape) button. If you press it repeatedly, you will escape from any menu level
and you will eventually reach the main menu. When that menu is reached, the ESC button becomes inoperative and
you have to select a function.
The purpose and use of these four functions is described in Section 4. To power off the AATU just switch the main
switch POWER located on the RCU rear panel in OFF position (so that the red stripe on the switch is hidden).

4. OPERATION

Operation of the AATU is simplified a great deal due to the high degree of automation and intuitive control. You can
start operation immediately after it is installed. However, to make full use of its possibilities and to fully configure to
your local conditions, we recommend you thoroughly read the following information.

4-1. Function OPERATE and AUTO TUNE procedure

This is the main function of the AATU. When you select it from the menu, you will see the function inscription:
Mode: OPERATE
-----_-----
12