Safety Precautions - LG LCP2850I-AN Owner's Manual

4 Safety Information
LG Electronics hereby declares that this/
these product(s) is/are in compliance
with the essential requirements and
other relevant provisions of Directive
1
2004/108/EC and 2011/65/EU.
Contact office for compliance of this
product:
LG Electronics Inc.
EU Representative, Krijgsman 1,1186
DM Amstelveen, The Netherlands

Safety Precautions

• Do not attempt to disassemble the camera
To prevent electric shock, do not remove screws or
covers. There are no user serviceable parts inside. Ask a
qualified service personnel for servicing.
• Avoid the camera with direct sunlight
Do not aim the camera at bright objects.Whether the
camera is in use or not, never face it with direct sunlight
or other extremely bright objects. Otherwise blooming
or smear may be caused.
• Handle the camera with care
Do not abuse the camera. Avoid striking, shaking, etc.
The camera could be damaged by improper handling
or storage.
• Do not use strong solvents or detergents
Use a dry cloth to the camera when it is dirty. If it is
hard to remove the dirt on the camera, use a mild
detergent and wipe it gently.
• Do not install this camera upside down
This camera is designed for mounting on the ceiling or
wall.If you install this camera upside down, for example,
mounted on the floor, it may cause malfunction.
• Do not use the camera in such places as shown below.
The lens may become cloudy due to condensation if
the camera is used under the following conditions.
› Rapid temperature fluctuation by switching an air
conditioner on and off.
› Rapid temperature fluctuation due to frequent
door opening and closing.
› Use in an environment where eyeglasses become
foggy.
› Use in a room filled with cigarette smoke or dust.
If the lens becomes cloudy due to condensation,
remove the dome cover and wipe all moist surfaces
with a soft cloth.
• Before operating, please check proper temperature,
humidity and power source ratings.
Use the camera under conditions where temperature
is from -20 °C to 50 °C and humidity is below 80 %. The
input power source is AC 24 V.