Canon imagePASS-P2 Service Manual page 89

9.
CAUTION:
Be sure to use the network cable with Category 5e or
higher. In addition, a shielded type (STP cable) is
recommended. When using the non-shielded type
(UTP cable), it may influence the surrounding
electronic equipments via network cable.
Use the correct power cord to match the location/area
of installation. Make sure not to leave unused power
cord at the site.
Straight Ethernet Cable
(for network connection)
2x
10.
Connect the power plug to the outlet of the host
machine.
11.
Connect the power plug to the outlet of the
equipment.
CAUTION:
Be sure to use an outlet of a system different from that
of the host machine.
12.
After turning ON the power of this equipment, turn
ON the main power switch of host machine.
13.
When the message "Turn ON the main power of the
host machine again." is displayed on the Touch
Panel, turn OFF the main power switch. (It may take
approx. 10 minutes before the message appears.)
CAUTION:
The equipment is automatically restarted only at the
first time when it is connected.
It takes about approx. 5 minutes until it is ready for use.
Do not press the buttons on the equipment until it is
ready for use.
14.
Turn ON the main power switch of the host machine
again.
15.
Check that the value of the following service mode
is "467".
COPIER > OPTION > INT-FACE > CNT-TYPE
16.
Exit from Service Mode.
84
6. INSTALLATION PROCEDURE