Canon imagePASS-P2 Service Manual page 40

7. Gently lift the power supply out of the chassis.
No.
1 Power switch
2 Screw (1 of 4)
● To replace the power supply
1. If you are replacing the power switch, locate the new power switch included with the replacement power supply kit. Orient
the power switch as shown in
2. Place the power supply inside the chassis (see
Make sure to fit the power connector through the cutout in the chassis. Align the mounting holes in the power supply with
the holes in the chassis.
3. Using the four screws that you removed earlier, secure the power supply to the chassis.
Attach the power supply duct using the two screws that you removed earlier.
4. Connect the HDD power cable to the SATA power connector on the HDD.
5. Connect the 4-pin (2x2) power cable to the 4-pin connector on the motherboard.
For the location of the motherboard connector, see
through 4 of the motherboard connector. The cable is keyed to fit only one way.
6. Connect the 24-pin power cable to the 24-pin connector on the motherboard.
For the location of the motherboard connector, see
way.
7. Make sure that all power connectors are properly aligned and securely connected.
8. Secure the power cables to the chassis using the two plastic clips on the base of the chassis.
9. Replace any tie-wraps that you may have removed or cut while removing the power cables earlier.
10. Reassemble the imagePASS and verify its functionality (see
■ Hard disk drive (HDD)
The factory-installed HDD is formatted and loaded with system software, network drivers, and printer fonts. The HDD is also used
to store spooled print jobs.
If you must replace the HDD, you must install the system software on the new HDD. If you are replacing the HDD, you need:
• The appropriate system software
• The latest version of user software (for networked computers that will print to the imagePASS)
For information about installing system software, see
Figure 26: Removing the power supply
"To remove the power supply and power switch" on page
"To remove the power supply and power switch" on page
"Motherboard jumpers" on page
"Motherboard jumpers" on page
"Installing System Software" on page
Item
"To reinstall and verify the imagePASS" on page
35
3. REPLACING PARTS
1
2
34.
34) .
23.Connect the power cable to pins 1
23.The cable is keyed to fit only one
38).
40.