Canon imagePASS-P2 Service Manual page 38

No.
1 Airflow direction
2 Fan guard
3 Rivet (1 of 4)
● To replace the chassis fan
1. If you are installing a new chassis fan, attach the fan guard to the correct face of the new fan.
Use the fan guard and four rivets that you removed from the old chassis fan. Position the guard against the face of the new
fan so that the airflow arrow on the fan points toward the guard (see
rivet all the way through its mounting hole until the rivet snaps into the locked position.
2. Take off the fan cable from the cable line hole.
No.
1 Fan cable
2 Cable line hole
3. Position the fan against the chassis.
When correctly positioned, the fan guard on the fan should face the motherboard, and the fan cable should reach its connector
on the motherboard.
1
Figure 23: Removing/replacing the chassis fan guard
2
1
Figure 24: Taking off the fan cable from the cable line hole
Item
"To remove the chassis fan" on page
Item
33
3. REPLACING PARTS
2
3
32). Push each