Canon imagePASS-P2 Service Manual page 58

3. If you are reinstalling the same version of system software, back up the current system configuration (see
system configuration" on page
4. Shut down the imagePASS (see
imagePASS power switch in the ON (|) position.
5. Power off the printer using the main power switch.
The imagePASS will automatically shut down.
6. Move the imagePASS power switch to the OFF (O) position.
7. Disconnect all external cables from the imagePASS, except the power cable and the printer interface cable.
NOTE:
Be sure to leave the power cable connected between the imagePASS and the power outlet.
8. Flip the service switches to boot mode (set the switch 1 to ON; switch 2 to OFF).
NOTE:
The LED display is mounted in upside-down orientation.
No.
1 Service switches
2 LED display
3 Flip the service switches from normal (OFF) position...
4 ...to service mode (ON) position.
9. Attach the prepared USB flash drive to one of the USB connectors on the imagePASS.
NOTE:
If dust covers are attached to the USB connectors, remove dust cover using needlenose pliers.
10. Power on the imagePASS by pressing the power switch to set ON (|), and then power on the printer using the main power
switch on the front.
Make sure that the imagePASS turns on.
11. Check the LED display for the file transfer activity. After confirming the LED activity starts and the LED display shows the
cyclic codes (C1 > C2 > C3 > C1...), turn off the printer using the main power switch on the front.
12. Wait while the files are transferred.
The file transfer may take approximately 5 to 15 minutes depending on the USB flash drive.
The LED on the flash drive shows sporadic activity during this time. After the imagePASS LED display shows the cyclic codes
(C1 > C2 > C3 > C1...), it eventually settles on 00. When all of the files have been transferred, the imagePASS automatically
shuts down.
13. Remove the USB flash drive from the imagePASS.
40).
"Starting, shutting down, rebooting, and restarting the imagePASS" on page
1
Figure 30: Service switches on the imagePASS
53
4. INSTALLING SYSTEM SOFTWARE
3
2
4
Item
"Backing up the
9).Leave the