Canon imagePASS-P2 Service Manual page 43

■ To reinstall and verify the imagePASS
1. Reseat all boards, cables, connectors, and other parts loosened or removed during service.
When routing cables in the imagePASS make sure that:
• Covers are securely installed after routing cables.
• Cables are not looped around circuit boards or components (such as capacitors and resistors).
• Cable routing does not interfere with the operation of internal components.
• Cables do not lie on or against any internal heating element.
• Cables do not interfere with removing or replacing components.
• Cables do not interfere with opening or closing imagePASS panels.
• Cables are not tangled.
• Cable slack is secured with a tie-wrap.
IMPORTANT:
Improper connection of the internal power cables can damage the imagePASS. See
connections" on page 17, which includes
2. Replace the cover on the imagePASS.
Make sure that all cables are fully inside the chassis before you replace the cover. Slide the cover until it engages the edge
of the chassis opposite the connector panel, and then lower the cover.
3. Replace the two screws that you removed earlier.
Tighten the screws to secure the cover to the imagePASS.
4. Reinstall the imagePASS on the side of the printer.
For detailed information about removing/installing the printer, see the installation instructions that accompany the printer (not
included in this service guide).
5. Connect the external cables that you removed during inspection or service.
Be sure to properly connect the following cables
14).
• Network cable
• Crossover Ethernet cable between the imagePASS and printer
• Printer interface cable
• imagePASS power cable
6. If you installed a new HDD, install system software (see
A spare HDD is shipped without preinstalled system software.
7. Make sure to configure the date and time in Setup (see
8. Before you leave the customer site, verify the imagePASS operation.
• Connect the imagePASS to the network (see
• Ask the site administrator to check the Setup options (see Configuration and Setup).
"To check cable connections" on page
Figure 29: Replacing the chassis cover
(see"imagePASS connector panel and LED diagnostic codes" on page
"Installing System Software" on page
"To configure the system date and time" on page
"imagePASS connector panel and LED diagnostic codes" on page
38
3. REPLACING PARTS
"Checking imagePASS internal
17.
40).
22).
14).