Error Codes Shown In The "Machine Error X X" Message - Brother MFC8440D Service Manual

7/13/2019
2.2

Error Codes Shown in the "MACHINE ERROR X X" message.

If the LCD shows the "PLS OPEN COVER" message, you can display the detailed error code
following the MACHINE ERROR, by using the maintenance-mode function code 82 described
in Chapter 7, Section 3.16.
NOTE:
When checking a PCB as instructed in the "Check:" column, check its harness also.
•
To check sensors, use the maintenance-mode function code 32 described in Chapter 7,
•
Section 3.9 (that is, press the
Error
Code
(Hex)
56 MP front cover opened.
57 Recording paper jam (inside DX unit).
Reserved
58 (Recording paper jam (no DX unit)).
Reserved
59
(Recording paper jam (inside MP tray)).
Reserved
5A
(Out of recording paper).
Reserved (Paper size error in case of
5B
double-sided print).
Reserved (Paper size error of one side only
5C
in case of double-sided print).
Reserved
5D
(MP tray sensor remains ON).
Reserved
5E (MP tray sensor remains OFF).
Reserved
5F
(DX unit sensor is inactivated).
Heater warming-up timeout error.
6A
(Heater does not reach 60
Heater warming-up timeout error.
6B (Heater does not reach 100
sec.)
Heater temperature exceeds the maximum
6C high temperature.
(270
Heater temperature lowers the minimum
6D low temperature.
(60
Heater temperature does not go up enough.
6E (Slower temperature rise rate than 2
sec. is detected.)
Heater hard limiter operates.
6F
Scanner motor does not synchronize with
71
the reference clock.
Cannot detect Beam Detect signal.
72
http://slidepdf.com/reader/full/brother-8840d-service-manual
and
3
Error factor
C within 11 sec.)
°
C within 15
°
C or more is detected for 1 sec.)
°
C or less is detected for 1 sec.)
°
Brother 8840D Service Manual
MFC-8440/8840D/8840DN, DCP-8040/8045D/8045DN
keys in the maintenance mode).
2
MP front cover
•
DX unit
•
DX unit
•
MP tray
•
Recording paper
•
Recording paper
•
MP tray sensor
•
MP tray sensor
•
DX unit sensor
•
Thermistor ASSY
•
Halogen lamp
•
Thermistor ASSY
•
Halogen lamp
•
Thermistor ASSY
•
Power supply PCB
•
Thermistor ASSY
•
• Power supply PCB
Halogen lamp
•
C/5 Power supply PCB
° •
Thermistor ASSY
•
Power supply PCB
•
Scanner motor
•
Scanner motor
•
MP tray open sensor
•
6-7
SERVICE MANUAL
Check:
210/361