Wsw 15 Redial Facility Setting - Brother MFC8440D Service Manual

7/13/2019
APPENDIX 3 FIRMWARE SWITCHS (WSW)
Selector
No.
1
2
3
|
6
7
8
Selectors 1 through 6:

The machine redials by the number of times set by selectors 3 through 6 at intervals set by
selectors 1 and 2.
This setting is effective only when selector 7 is set to "0."
Selectors 7: Redialing for no response sent from the called terminal

This selector determines whether or not the machine redials if no G3 command response
comes from the called station after dialing within the time length set by selectors 7 and 8 of
WSW09.
Selectors 8: CRP option

If a command error occurs in the equipment (calling station), the equipment usually waits for
three seconds and then makes a retry three times. This CRP option is a request command
that can be sent from the called station for requesting the calling station to retry the failed
command immediately.
http://slidepdf.com/reader/full/brother-8840d-service-manual
WSW15 (REDIAL facility setting)
Function
Selection of redial interval
No. of redialings
Redialing for no response sent
from the called terminal
CRP option
Selection of redial interval and No. of redialings
Brother 8840D Service Manual
Setting and Specifications
No. 1 2
0 0
0 1
1 0
1 1
No. 3 4
0 0
0 0
0 0
0 0
|
1 1
0: Redialing
0: Disable
A-22
: 5 minutes
: 1 minute
: 2 minutes
: 3 minutes
5 6
0 0 : 16 times
0 1 : 1 times
1 0 : 2 times
1 1 : 3 times
|
1 1 : 15 times
1: No redialing
1: Enable
315/361