Brother HL-L9300CDW Service Manual page 313

■
Switching of timing to execute Auto Registration
<Function>
Relative displacement between Cyan, Magenta, Yellow, and Black is detected using the
registration mark sensor, and the Auto Registration is executed at the timing when the
displacement value exceeds the stipulated threshold value.
This function is to switch the threshold value which is used as the timing to execute Auto
Registration. The threshold value can be switched in three phases between High, Mid, and
Low.
LCD
Regi Freq=Mid
Regi Freq=High
Regi Freq=Low
"*" is displayed at the end of the currently specified function in the LCD display.
Note:
It can be set regardless of the Auto Registration switching function in the function menu.
Even if this function is switched, it does not affect the timing to execute Auto Registration in
the function menu.
<Operating procedure>
Model without touch panel
(1) Press the
"MAINTENANCE 45" on the LCD in the
initial state of the maintenance mode.
Then, press the OK key. "USBNo." is
displayed on the LCD.
(2) Press the
"Regi Freq" and then press the OK or
Go key.
(3) Press the
"Regi Freq=Mid", "Regi Freq=High" or
"Regi Freq=Low", and press the OK or
Go key.
(4) "Accepted" is displayed on the LCD,
and the machine returns to the initial
state of the maintenance mode.
The frequency to execute Auto Registration is middle. (default)
The frequency to execute Auto Registration is high.
The frequency to execute Auto Registration is low.
or key to display
or key to display
or key to select
5-25
Description
Model with touch panel
(1) Press the 4 and 5 keys in this order in
the initial state of the maintenance
mode. "USBNo." is displayed on the
LCD.
(2) Press the or
"Regi Freq" and then press the Mono
or SET key.
(3) Press the or
"Regi Freq=Mid", "Regi Freq=High" or
"Regi Freq=Low", and press the Mono
or SET key.
(4) "Accepted" is displayed on the LCD,
and the machine returns to the initial
state of the maintenance mode.
key to display
key to select
Confidential