HL-L9200CDW / HL-L9200CDWT
Quick Setup Guide
Unpack the machine and check the components
Drum Unit
(pre-installed)
Toner Cartridges
(Black, Cyan, Magenta and Yellow;
pre-installed)
1
Remove the packing material from the machine
1
2
2
Load paper in the paper tray
3
Connect the power cord and turn on the machine
Waste Toner Box
Power Cord
(pre-installed)
Belt Unit
(pre-installed)
3
4
Adjust the paper guides.
The latest manuals are available at Brother Solutions Center:
http://solutions.brother.com/.
Not all models are available in all countries.
Quick Setup Guide
CD-ROM
Product Safety Guide
4
Select your language
1.
Press
2.
Press your language.
3.
On the machine's Touchpanel, press
Read the Product Safety Guide first, and then read this Quick Setup
Guide for the correct installation procedure.
NOTE:
•
The components included in the box and the AC power plug
connection may differ depending on your country.
•
The illustrations in this Quick Setup Guide are based on the
HL-L9200CDW.
•
You must purchase the correct interface cable for the interface you
want to use:
USB cable
We recommend using a USB2.0 cable (Type A/B) that is no more
than 6 feet (2 meters) long.
Network cable
Use a straight-through Category 5 (or greater) twisted-pair cable
for 10BASE-T or 100BASE-TX Fast Ethernet Network.
1
2
> General Setup > Local Language.
.
Version 0
ENG
3
Need help?
Do you have a question about the HL-L9200CDW and is the answer not in the manual?
Questions and answers