Table of Contents
Advertisement
Printing a network
setup page
Note:
If an optional MarkNet
card is installed in slot 1, you
see Print Net1 Setup on the
display. If the card is installed in
slot 2, you see Print Net2 Setup.
42
Verify printer setup
3
Turn on the printer. Setup Required appears on the operator
panel.
If the printer is attached locally (directly to a computer), leave
the computer and any other attached devices turned off. You
will turn these on in a later step.
4
Press Go. The message Performing Self Test appears on
the operator panel display while the printer warms up. After the
printer completes its internal tests, the Ready message
indicates the printer is ready to receive jobs.
If you see Setup Required instead of the Ready message,
check to make sure you have removed all the packing
materials and that you have installed the options correctly. See
Steps 1 through 6 for detailed instructions.
If you see a message other than Setup Required or Ready,
refer to the publications CD for instructions on clearing the
message. Click Printing, and then click Understanding
printer messages.
5
If you attached your printer to a network, continue with "Printing
a network setup page."
Otherwise, go on to "Printing a menu settings page" on
page 43.
If the printer is attached to a network, print a network setup page to
verify the network connection. This page also provides important
information that helps you configure for network printing.
1
Press Menu until you see Utilities Menu, and then press
Select.
2
Press Menu until you see Print Net Setup, and then press
Select. The network setup page prints and the printer returns
to Ready status.
Advertisement
Table of Contents
