Printing A Network Setup Page; Printing A Font Sample List; Printing A Directory List - IBM InfoPrint 1634 User Manual

3
Press until Reports appears, and then press
4
Press until Menu Settings Page appears, and then press
Printing Menu Settings appears. After the menu settings page prints, Ready appears.

Printing a network setup page

If the printer is attached to a network, print a network setup page to verify the network connection. This page also provides
important information that aids network printing configuration.
1
Make sure the printer is on and Ready appears.
2
From the control panel, press
3
Press until Reports appears, and then press
4
Press until Network Setup Page appears, and then press
After the network setup page prints, Ready appears.
Note: If an optional internal print server is installed, Print Network <x> Setup Page appears.
5
Check the first section on the network setup page, and confirm that Status is "Connected."
If Status is "Not Connected," the LAN drop may not be active, or the network cable may be malfunctioning. Consult a
system support person for a solution, and then print another network setup page.

Printing a font sample list

To print samples of the fonts currently available for your printer:
1
Make sure the printer is on and Ready appears.
2
From the control panel, press
3
Press until Reports appears, and then press
4
Press until Print Fonts appears, and then press
5
Press until appears next to PCL Emul Fonts, PostScript Fonts, or PPDS Fonts, and then press
After the font sample list prints, Ready appears.

Printing a directory list

A directory list shows the resources stored in flash memory or on the hard disk.
1
Make sure the printer is on and Ready appears.
2
From the control panel, press
3
Press until Reports appears, and then press
4
Press until Print Directory appears, and then press
Printing Directory List appears. After the directory list prints, Ready appears.
.
.
.
.
.
.
.
49
.
.
.
.
.