Parrot Uncle BBCF235 Owner's Manual page 21

7. Remote Control Procedures
7.2: Installation of Batteries
The Remote Control Transmitter is powered by two
AAA Alkaline Batteries.
To prevent possible battery leakage damage, be sure
to remove the Batteries when the Control is not to be
used for an extended period of time.
Remove the Battery Cover by pressing firmly below the
arrow and sliding the Cover off the Remote Control.
Install two new AAA Alkaline Batteries into the Battery
Compartment following the correct Battery placement
printed on the Compartment (Figure 32).
NOTE: Never use old and new Batteries together in
unit.
Replace the Battery Compartment cover by sliding the
Cover back onto the Remote Control.
7.3: Setting Operating
Frequency of Remote Control
Remove the Battery Cover by pressing firmly below
the arrow and sliding the Cover off the Control
(Figure 33).
Your Remote Control has Code Switches which must
be set in one of 32 possible code combinations.
The five levers (numbered 1, 2, 3, 4, and 5) on the
switches are factory-set in the ON (up) position.
Change the Switch settings as follows:
Slide the five Switch Levers in the Remote Control to
your choice of ON (up) or down positions. Use a ball-
point pen or small screwdriver and slide the Levers
firmly up or down (Figure 33).
The sixth Switch marked ON and I is for dimming
control of lights: Set Switch to ON to allow for dimming
of the lights. Set Switch to I for no dimming of the lights.
Figure 32
BATTERY
COMPARTMENT
COVER
Figure 33
NOTE: If your Fan and Light go on and off without
using your Control, you may be getting interference
from other remote units such as garage door
openers, car alarms or security systems.
To remedy this situations, simply change the
combination code in your Remote Control
Transmitter.
21
(Continued)
REMOTE CONTROL
LEVERS
ON
1 2 3 4 5
I
CODE
SWITCHES
REMOTE CONTROL