Axxess AX-FT901 Manual

Fiat 500 2015 / 500L 2014
† For Continental Mopar head unit
INTERFACE FEATURES
• Provides accessory power
• Designed for non-amplified models
• Provides NAV outputs (parking brake, reverse, speed sense)
• Retains audio controls on the steering wheel
* Attention! The aftermarket radios backup camera input will be used to display the vehicle settings. If the radio doesn't have a backup camera
Input, then there will be no visualization of the vehicle settings. An externally mounted screen could be substituted in this situation.
INTERFACE COMPONENTS
• AX-FT901 interface
• ASWC-1 interface
• AX-FT901 harness
• ASWC-1 harness
AxxessInterfaces.com
Data Interface with SWC & Factory Display Retention
(with U-Connect)
• Retains balance and fade
• Retains most of the vehicle settings that was displayed on the
factory radio *
• Micro "B" USB updatable
© COPYRIGHT 2018 METRA ELECTRONICS CORPORATION
AX-FT901
I N S TA L L AT I O N I N S T R U C T I O N S
†
TABLE OF CONTENTS
Connections to be made ....................................2-3
Installing the AX-FT901 interface ..........................3
Programming the ASWC-1 interface ................. 3-4
Screen operation ................................................4-6
TOOLS REQUIRED
• Wire cutter • Crimp tool • Solder gun • Tape
• Connectors (example: butt-connectors, bell
caps, etc.)
CAUTION!
All accessories, switches, climate
controls panels, and especially air bag indicator
lights must be connected before cycling the
ignition. Also, do not remove the factory radio
with the key in the on position, or while the
vehicle is running.
REV. 5/10/18 INSTAX-FT901