Table of Contents
Advertisement
PROGRAM TIMER operation procedure
■ The timer operations that consist of the combination of the timer being set at both on and off. Once this has been set and operations started, operations
will commence and end at the same time every day as long as the ON/OFF button is not pressed.
About Amenity facilities
Amenity facilities enable to start the operation a little earlier, so that the room
should approach optimum temperature at ON time when the operation is started
by ON-TIMER.
• Mechanism
The room temperature is checked
60 minutes before the timer is
at ON. Depending on the tem-
perature at that time, the operation
starts 5 to 60 minutes before the
timer is at ON.
• The Amenity facility only func-
tions for COOL operation mode
(including AUTO). It does not
work for DRY mode.
Present time setting procedure
■ When inserting the batteries, the present time is automatically set to time setting mode.
RMA012A105G_J-L_RevC_EN.indb 14
RMA012A105G_J-L_RevC_EN.indb 14
Example: When it is desired to stop at 22:30, and then start operation at 8:00, near the set
■ OFF TIMER operation setting
■ ON TIMER operation setting
In COOL operation
(Stop) Operation starts
(Operation)
Set temperature
Check the room
Set time
temp. 60 mins.
in advance.
Example: Set to 10:30.
1
Press the ACL switch.
Press with the tip of a ballpoint pen, etc.
The time indicator blinks and can be set to the current time.
2
Press the "
(Set to 10:30)
3
Press the ON/OFF button.
The indication changes from blinking to steady lighting and the setting is complete.
NOTE
• The timer operation is set on the basis of the present time, so please set it correctly.
• The remote control data is reset when the present time is set.
– 14 –
temperature.
Set by the procedures on page 12.
Set to
Set by the procedures on page 13.
Set to
The setting of the lighting of the timer light (yellow) of this unit is complete.
The time will be displayed on the remote control unit. The display will change
depending on the operational status.
(Stopped)
Changing of set time
Set a new time by using the OFF TIMER or ON TIMER button.
Releasing procedure
Press the CANCEL button to turn off the timer indicator.
About SLEEP operation
When SLEEP operation is selected, the room temperature is automatically
controlled after a while, ensuring that the room is not too cold during cooling
or too warm during heating.
• During COOL : the preset temperature is lowered by 1°C at the start of
SLEEP operation (when the timer is set). After that, the temperature goes up
by 1°C every an hour to become 2°C higher.
or
" button.
(Operating)
Press within
60 sec.!
12/6/2018 11:48:22 AM
12/6/2018 11:48:22 AM
Advertisement
Chapters
Table of Contents
