Table of Contents
Advertisement
Air fl ow direction adjustment procedure
■ Up/down direction can be adjusted with the AIRFLOW
the mode changes as follows:
Change to AIRFLOW (UP/DOWN) mode.
■ Left/right direction can be adjusted with the AIRFLOW
button the mode changes as follows:
Change to AIRFLOW (LEFT/RIGHT) mode.
MEMORY FLAP (FLAP OR LOUVER STOPPED)
When you press the AIRFLOW (UP/DOWN or LEFT/RIGHT) button once while the fl ap or louver is
operating, it stops swinging at an angle.Since this angle is memorized in the microcomputer, the fl ap
or louver will automatically be set at this angle when the next operation is started.
•
Avoid constant airfl ow to the body for hours on end.
•
When in COOL or DRY operation, do not operate for hours on end with the air
fl ow blowing straight down. Otherwise, condensation may appear on the outlet
grill and drip down.
•
Do not try to adjust the fl aps and louvers by hand, as the control angle may
change or the fl ap or louver may not close properly.
3D AUTO operation procedure
Fan speed and air flow direction are automatically controlled, allowing the entire room to be efficiently conditioned.
RMA012A105G_J-L_RevC_EN.indb 11
RMA012A105G_J-L_RevC_EN.indb 11
Adjusting air fl ow direction
(UP/DOWN) button on the remote control. Each time when you press this button
(Flap stopped)
(LEFT/RIGHT) button on the remote control. Each time when you press this
(Louver stopped)
(Swing)
WARNING
CAUTION
1
2
NOTE
• 3D AUTO operation is cancelled when you switch the operation program.
• The 3D AUTO light illuminates during 3D AUTO operation.
– 11 –
(Swing)
• Recommended angle of the fl ap when stopping
COOL, DRY
Press the ON/OFF button.
Press the 3D AUTO button.
Each time the 3D AUTO button is pressed, the indicator is switched
in the order of:
(3D AUTO)
Releasing procedure
Press the 3D AUTO button to turn off the 3D AUTO indicator.
(Horizontal
blowing)
No indication
(Normal operation)
12/6/2018 11:48:21 AM
12/6/2018 11:48:21 AM
Advertisement
Chapters
Table of Contents
