Program Timer Operation; High Power / Economy Operation; Self Clean Operation; Auto Restart Function - Mitsubishi Heavy Industries DXK09Z6-W1 User Manual

PROGRAM TIMER operation

The timer operations that combinations ON and OFF TIMER.
Once this has been set the timer operations will be repeated at the
same time every day unless the ON/OFF button is pressed.
Example:
Present time is 21:00. The air-conditioner running.
When it is preferred to stop at 22:30, and then start operation at 8:00, near
the set temperature.
1
OFF TIMER operation setting
Set by the procedures on page 10.
Set to
2
ON TIMER operation setting
Set by the procedures on page 10.
Set to
The setting of the lighting the timer light (yellow) of this unit is
complete.
How to cancel;
Press the CANCEL or ON/OFF button to turn off the timer
display.
Changing of set time;
Set a new time by using the OFF TIMER or ON TIMER button.
NOTICE
Operation starts first and then stops after.
Operation stops first and then starts after.
HIGH POWER / ECONOMY
operation
1
2
NOTICE
• During the HIGH POWER operation, the room temperature is
not controlled.
Remote control display
Press the ON/OFF button.
Press the HIGH POWER/
ECONO button.
■
When the mode is AUTO,
COOL or HEAT
Each time the button pressed,
the display changes as below.
No display
(HIGH (ECONOMY) (Normal
POWER) operation)
■
When the mode is DRY, FAN
or PROGRAM TIMER
Each time the button pressed,
the display changes as below.
No display
(ECONOMY) (Normal
operation)

SELF CLEAN operation

This should be run after AUTO, COOL and DRY operation to dry up
the inside of the unit and prevent to grow the mold and bacteria.
NOTICE
• Two hours later, the air-conditioner stops automatically.
• If you want to stop the air-conditioner immediately, press the
ON/OFF button.
• The RUN light illuminates during SELF CLEAN operation.
• This is not a function for removing mold, germs or grime that
have already adhered to the unit.

Auto restart function

■ This function records the operational status of the unit immediately
prior to be switched off by a power cut, and then automatically
resumes operations after the power has been restored.
■ The following settings will be canceled:
 Timer settings
 HIGH POWER operations
EN-11
1 Press the CLEAN switch with
the tip of a ball point pen to
active this function.
Each time the CLEAN switch is
pressed, the display is switched in
the order of.
No display
SELF CLEAN on SELF CLEAN off
(Default)