Air Flow Direction Adjustment Procedure - Mitsubishi Heavy Industries SRK20HG User Manual

Air flow direction adjustment procedure

I Up/down direction can be adjusted with the AIRFLOW button on the remote control. Each time when you press this button the mode changes
as follows:
Change to AIRFLOW mode.
NOTE
• When heating operation starts, the cold air outlet is blocked, so the flap move to the horizontal position, and resume the position that was set after the warm air
output begins.
• When the compressor stops because the room temperature is higher than the temperature setting and it is in DEFROSTING operation, the flap will be in the
horizontal position.
• The air flow direction cannot be set in the instances above. Change the air flow direction settings after the warm air starts flowing and it moves to the airflow
direction that had been set.
MEMORY FLAP (FLAP STOPPED)
When you press the AIRFLOW button once while the flap is operating, it stops swinging at an
angle.Since this angle is memorized in the microcomputer, the flap will automatically be set at this
angle when the next operation is started.
• Recommended angle of the flap when stopping
(Slant forward
HEAT
blowing)
• Avoid constant airflow to the body for hours on end.
• When in COOL or DRY operation, do not operate for hours on end with the air
flow blowing straight down. Otherwise, condensation may appear on the outlet
grill and drip down.
• Do not try to adjust the flaps by hand, as the control angle may change or the flap
may not close properly.
Adjusting air flow direction
(Flap stopped)
(Horizontal
COOL, DRY
DANGER
CAUTION
– 8 –
Adjusting left/right air flow direction
Adjust the direction by moving the left/right
air flow fin by hand.
blowing)
Please stop the air conditioner when
adjusting the air flow direction.
(Swing)
CAUTION