Grundig GWN 59464 C User Manual page 46

2. Open the filter cover.
3 Follow the below procedures in order to drain water.
If the product has an emergency water draining hose, in order to drain the water:
4 Clean any residues inside the filter as well as fibers, if any, around the pump
impeller region.
5. Replace the filter.
6. If the filter cap is composed of two pieces, close the filter cap by pressing on
the tab. If it is one piece, seat the tabs in the lower part into their places first, and
then press the upper part to close.
46 / EN
If the filter cap is composed of two
pieces, press the tab on the filter cap
downwards and pull the piece out
towards yourself.
If the filter cap is one piece, pull the
cap from both sides at the top to
open.
You can remove the filter cover by
slightly pushing downwards with a
thin plastic tipped tool, through the
gap above the filter cover. In order
to remove the cover, do not use
metal tipped tools.
a Pull the emergency draining hose
out from its seat.
b Place a large container at the end
of the hose. Drain the water into the
container by pulling out the plug
at the end of the hose. When the
container is full, block the inlet of the
hose by replacing the plug. After
the container is emptied, repeat the
above procedure to drain the water
in the product completely.
c When draining of water is finished,
close the end by the plug again and
fix the hose in its place.
d Turn and remove the pump filter.
Washing Machine / User's Manual