Installation Of The Water Heater - Timberk T-WI3-P10-SC Instruction Manual

IM2022
7.

INSTALLATION OF THE WATER HEATER

When installing the water heater, strictly follow the laws, ordinances, regulations and standards
(safety regulations, rules and procedures for disposal, technical and electrical safety regulations,
etc.) in force in your country, as well as the regulations of local electricity and water supply
companies.
Mounting
When determining the location of the water heater, it is necessary to provide free access to it at
the rate of at least 0.3 m from above, below and from the sides. This will make it possible to
maintain and regulate the water heater as conveniently as possible. After choosing the location
of the water heater, determine the points for the holes for the mounting screws. Drill 2 holes of
appropriate depth in the wall using a drill bit that is the right size for the dowels and screws
supplied with the water heater. Insert the dowels into the holes in the wall and screw the
mounting screws into them. Do not fully tighten the screws. The heads of the screws should
recede from the wall by the distance necessary for hanging the water heater and its reliable
fastening. Hang the water heater on the screws and check the reliability of fastening.
ATTENTION!
The device must be installed on the wall strictly horizontally with the nozzles down.
For more reliable fastening, you can use a through hole in the bottom of the rear panel by
screwing an additional screw into the wall through it.
NOTE!
Installation of the water heater at the place of operation and power supply must be carried out by
a specialized organization, representatives of the manufacturer's service department or
specialists who have permission to carry out work on the installation of electrical equipment, in
compliance with safety requirements. In case of violation of the instructions for installing and
operating the water heater, the device is not subject to warranty service, and the manufacturer is
not responsible.
Fig. 4
21