Using Burners; Using Hot Plates - Bertazzoni AMN855EXV Installation, Maintenance And Use Instructions

Free-standing cookers 80x50cm
Table of Contents

Advertisement

Available languages

Available languages

The symbol
shows the oven fan working button as to allow the oven to operates with fan assisted gas.
operation of the oven prevents the operation of the electric grill, which therefore cannot be used with the fan in
action.
the symbol
shows the operating key for the rotisserie (only gas oven)
the symbol
shows the ignition key for the oven light (all except the electric fan oven)
the symbol
shows the push-button for burner ignition
shows if keys are in position "on" or "off"
the symbol
A diagram is etched on the control panel above each knob which indicates which burner corresponds to that knob. The
burners can be ignited in different ways depending on the type of appliance and its specific characteristics:
- Manual lighting (it is always possible even when the power is cut off): Push and turn the knob counterclockwise
that corresponds to the burner selected, setting it to the MAXIMUM position at the etched star (large flame Fig.19-20) and
place a lit match up to the burner.
- Electric ignition: Push and turn the knob counterclockwise that corresponds to the burner selected, setting it to the
MAXIMUM position (large flame Fig. 19-20) and keep on pressing the knob in correspondence of the ignition symbol
marked with a star (for cookers equipped with ignition trough knob) or press the ignition button marked with a star and
release it as soon as the burner has ignited.
- Burner ignition equipped with safety device (thermocouple)(fig.21): Push and turn the knob counterclockwise that
corresponds to the burner selected, setting it to the MAXIMUM position at the etched star (large flame Fig. 19-20), press
the knob and activate one of the above-mentioned ignition devices. Once ignited, keep pressing the knob for about 10
seconds to allow the flame to heat the thermocouple. If the burner goes out after releasing the knob, repeat the entire
operation.
Note: It is recommended not to try to ignite a burner if the relative flame cap is not in the correct position.
Tips for using burners correctly:
- Use suitable pots for each burner (see tab. 4 and Fig. 22).
- When the liquid is boiling, turn the knob to the MINIMUM position (small flame Fig.19-20).
- Always use pots with a cover.
TABLE N°4
BURNER
Semi-rapid
Double ring
WARNING: If the power is cut off, the burners can be lit with matches. When cooking foods with oil and fat,
which are very flammable, the user should not leave the appliance unattended. If the appliance is equipped with
a glass cover, such a cover may break when heated. Turn off all burners before lowering the cover. Do not use
sprays near the appliance when it is being used. When using the burners, make sure that the handles of the pots
are correctly positioned. Keep children away from the appliance. If equipped with a cover, before being closed,
any food deposits should be cleaned off the built-in surface.
NOTE: The use of a gas cooking appliance produces heat and humidity in the room where it is installed.
Therefore, proper aeration in the room is needed while ensuring that natural ventilation openings remain
unobstructed (Fig.3) and activating the mechanical aeration device/exhaust hood or electric fan (Fig. 4 and Fig.
5). Intensive and continuous use of the appliance may require additional aeration, for example by opening a
window, or more efficient aeration by increasing the power of the mechanical exhauster, if installed.
Warning: we suggest to utilize pots with the bottom made of tender aluminium to avoid permanent signs on the
surface of the pan supports, that cannot be removed with a normal washing.
hot plates: These hot plates are controlled by a switch with 6 settings (Fig. 23-24). The hot plates are turned on by
turning the knob to the desired position. A mark is etched on the control panel of the appliance indicating what plate
corresponds to the knob. A red light turns on, which is also installed on the control panel, indicating that the hot plate is
on.

USING BURNERS

PAN DIAMETER recommended (cm)
Auxiliary
Rapid

USING HOT PLATES

12-14
14-26
18-26
22-26
23
ATTENTION: Use pots with a
flat bottom
The fan

Advertisement

Table of Contents
loading

Table of Contents