Page 1
INSTALLATION, MAINTENANCE AND USE INSTRUCTIONS FOR FREE-STANDING COOKERS 60x60 cm (type M6V) AM64C61BX AM64C71BX TU64C61BX TU64C71BX READ THE INSTRUCTION BOOKLET BEFORE INSTALLING AND USING THE APPLIANCE. The manufacturer will not be responsible for any damage to property or to persons caused by incorrect installation or improper use of the appliance.
Any walls of the adjacent furniture pieces and the wall behind the cooker must be made with heat-resistant material that can withstand a minimum overtemperature of 65 K. WARNING: the connection to the gas network must only use metal flexible pipes that conform with the national standards in force.
When making the connection, take care not to apply excessive stress by counterbalancing tightening force. Ensure that the available gas supply is the same as the gas type label affixed near the gas connection point. If not, contact Bertazzoni Service Center for a Gas Conversion Kit. Natural Gas The natural gas regulator supplied must be fitted for natural gas.
Page 5
2) Remove the grids from the work surface (Fig. 11). 3) Remove the burners (Fig. 11). 4) Unscrew the nozzles using a 7 mm spanner, and replace them (Fig.12) with those needed for the new type of gas according to what is indicated in Table 1. Follow the instructions below to change the oven burner nozzle: 1) Remove the oven floor (Fig.
When satisfied with the appliance, please instruct the user on the correct method of operation. In case the appliance fails to operate correctly after all checks have been carried out, please call the Bertazzoni Service Center. APPLIANCE MAINTENANCE...
For glass doors Do not use harsh abrasive cleaners or sharp metal scrapers to clean the oven door glass since they can scratch the surface, which may result in shattering of the glass. Do not use steam cleaners to clean the appliance. NOTE: various parts of the cooker heat up reaching temperatures which seem very high but which are actually fully within safety limits.
CONTROL PANEL DESCRIPTION On the control panel, small symbols show the function of each knob or key. Here as follows are the several controls that a cooker can have: the symbol shows the disposition of burners on the worktop, the full dot identifies the burner in object (in this case the front left burner).
USING THE GAS OVEN All the gas oven cookers are equipped with a thermostat and safety device to adjust the cooking temperature. The oven temperature is set by turning the knob counterclockwise to match the indicator with the temperature selected. The gas oven can be combined with a gas grill or an electric grill.
- the symbol indicates that the 1300W bottom heating element and external 900W top heating element are on; - the symbol indicates that only the external 900 W top heating element is on; - the symbol indicates that only the 1300W bottom heating element is on; - the symbol indicates that only the 2000 grill heating element is on (see specific section);...
USING THE ELECTRIC OVEN WITH FAN When using the oven for the first time, leave it on for maximum 30 minutes at a temperature of 250°, to eliminate smell from the internal seals. Before cooking foods, make sure the oven reaches the selected temperature and the orange light is off. This type of oven has a round heating element inside, where the fan for forced air circulation in a horizontal direction is positioned.
USING THE STATIC ELECTRIC GRILL The electric grill can be combined with the gas or electric oven. With a gas oven + electric grill combination, the grill is operated from the oven thermostat knob. The electric grill for gas oven cookers has a 2500W rating. IMPORTANT: When using the electric grill in electric oven cookers, do not turn the thermostat knob to more than 150°C to prevent overheating the oven front;...
Page 14
The symbols on the display: Automatic programme is working. (* in some models there is the writinq 'Auto' instead of A). The appliance is ready for manual use (not automatic). When blinking, the programmer is in setting hour mode. • Timer set.
To delete a semi-automatic or automatic cooking program, with the A symbol on, touch together the - and + keys for at least 2 seconds or anyway up to see the (2) and the disabling of A symbol. How to delete the countdown timer To delete the counting of the timer, which symbol is ) t touch the M key for at least 2 seconds or anyway up to see the ) symbol blinking.
• Burners not igniting properly. • Gas valves, which are difficult to turn. In case the appliance fails to operate correctly, contact Bertazzoni Service Center. CLEANING THE APPLIANCE Before any cleaning, unplug the appliance and turn off the gas tap.
This data is provided on the data label adhered to the base of the appliance and on the duplicate data label. Always use original Bertazzoni spare parts.
Page 27
TU64C61BX BERTAZZONI GROUP ABN 38 069 686 326 650 Bridge Road, Richmond, Victoria 3121 Service & Spare Parts: 1300 748 308 Bertazzoni After Sales Service - P.O. Box 543 SOMERTON VIC 3061 Email: customercare@bertazzonigroup.com.au...
Need help?
Do you have a question about the AM64C61BX and is the answer not in the manual?
Questions and answers