ICON Health & Fitness PRO-FORM POWER 1495 User Manual page 35

SYMPTOM: The displays of the console do not
function properly
a. Remove the key from the console and UNPLUG
THE POWER CORD. Remove the five #8 x 3/4"
Tek Screws (14). Carefully pivot the Motor Hood
(65) off.
a
65
14
Locate the Reed Switch (52) and the Magnet (50)
on the left side of the Pulley (49). Turn the Pulley
until the Magnet is aligned with the Reed Switch.
Make sure that the gap between the Magnet
and the Reed Switch is about 1/8 in. (3 mm). If
necessary, loosen the #8 x 3/4" Tek Screw (14),
move the Reed Switch slightly, and then retighten
the Screw. Reattach the Motor Hood (not shown)
with the #8 x 3/4" Screws (not shown) and run the
treadmill for a few minutes to check for a correct
speed reading.
Top
View
52
14
1/8 in.
SYMPTOM: The incline of the treadmill does not
change correctly
a. Calibrate the incline system (see step 4 on
SYMPTOM: The iFit mode does not function
correctly
a. If the iFit mode is not functioning correctly, make
14
SYMPTOM: The treadmill will not connect to the
wireless network
a. Make sure that the wireless settings on your con-
14
b. Make sure that the settings for your wireless net-
SYMPTOM: The walking belt slows when walked on
a. Use only a surge suppressor that meets all of the
b. If the walking belt is overtightened, treadmill per-
49
50
35
page 31).
sure that the treadmill has the most current firm-
ware available (see step 3 on page 31).
sole are correct (see step 4 on page 32).
work are correct.
specifications described on page 19.
formance may decrease and the walking belt may
become damaged. Remove the key and UNPLUG
THE POWER CORD. Using the hex key, turn both
idler roller screws counterclockwise, 1/4 of a turn.
When the walking belt is properly tightened, you
should be able to lift each edge of the walking belt
2 to 3 in. (5 to 7 cm) off the walking platform. Be
careful to keep the walking belt centered. Then,
plug in the power cord, insert the key, and run the
treadmill for a few minutes. Repeat until the walk-
ing belt is properly tightened.
b
2–3 in.
Idler Roller Screws