2. Make sure that the power cord is unplugged.
Attach the Left Wheel Cap (111) to the Base (94)
with two #8 x 3/4" Screws (2).
Attach the Right Wheel Cap (not shown) to
the Base (94) in the same way.
3. Pull the Upright Wire (81) and the base ground
wire (A) through the indicated hole in the
Base (94).
If there is a screw (B) pre-installed in the side
of the Base (94), remove and discard it. Attach
the ground wire (A) to the Base with a #8 x 1/2"
Silver Screw (10).
Press the Grommet (77) into the square hole in
the Base (94).
2
94
2
3
Hole
81
10
10
111
77
B
A
94