ICON Health & Fitness PRO-FORM POWER 1495 User Manual page 17

18. Remove the 5/16" Nut (12) and the 5/16" x 2 1/4"
Bolt (3) from the bracket on the Latch Crossbar
(38).
Align the upper end of the Storage Latch (53)
with the bracket on the Latch Crossbar (38).
Insert a 5/16" x 2 1/4" Bolt (3) through the
bracket. This should push a spacer (G) out of the
other end. Discard the spacer.
Attach the Storage Latch (53) with the 5/16" x 2
1/4" Bolt (3) and a 5/16" Nut (12).
Lower the Frame (56) (see HOW TO LOWER
THE TREADMILL FOR USE on page 33).
19. Firmly tighten the four 3/8" x 2 3/4" Screws (7)
and then the four 3/8" x 1 1/4" Screws (110)
(only one side is shown).
Press the Left and Right Base Covers (82, 83)
onto the Base (94) until they snap into place.
20. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic
on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill. To
avoid damage to the console, keep the treadmill out of direct sunlight. Keep the included hex keys in a secure
place; one of the hex keys is used to adjust the walking belt (see pages 35 and 36). Note: Extra parts may be
included.
18
12
38
G
56
19
7
110
94
17
3
53
82
83