Table of Contents
Advertisement
Example: The following fi le will upload the BIOS and an application.
[FUNCTION]
Upload application
[DIR]
NEW AHU
[NAM]
BIOS+APPL+LOGSv58B36
bisn509.bin
[IUP]
AHU_EN.iup
AHU_IT.iup
[BIN]
AHU.blb
[DEV]
AHU.dev
[GRP]
AHU.grp
[PVT]
AHU.pvt
[LCT]
AHU.lct
10.3.3 Automatic upload
To automatically upload the parameter memory using the fi rst
confi guration fi le shown in the preceding paragraph, access the system
menu as previously described and proceed as follows:
1.
Select automatic mode. A screen is shown describing the function
of the buttons. Press Enter to confi rm.
Fig. 10.o
2.
Confi rm by selecting Prg. A screen is displayed requesting
confi rmation to upload the non-volatile memory. Press Enter to
confi rm.
Fig. 10.p
Copyright HPL March 2021
3.
At the end a message will ask the user to remove the pendrive.
10.3.4 Upload in autorun mode
Uploading in autorun mode is a special case of uploading in automatic
mode. Unlike automatic mode, the user must wait for a specifi c message
to appear on the display to start or disable the operation described in
the confi guration fi le. To upload a fi le in autorun mode, a confi guration
fi le must be created and named "autorun.txt". Example of uploading
BIOS+application. The upload involves two steps: fi rst the BIOS is updated
and then the application. The information is shown on the pRack's built-
in display and on the pGDE terminal, when both are featured.
Procedure:
1.
Connect the pendrive to port A.
2.
After a few seconds, Autorun mode starts. Press Enter to confi rm.
3.
The validity of the FW is checked and the BIOS is loaded.
4.
The display fl ashes to indicate that after loading the new BIOS the
controller is being reset.
pGD
5.
The test phase starts.
91
Page 140 of 172
Fig. 10.q
USB key
Fig. 10.r
Fig. 10.s
Fig. 10.t
NO LINK
Fig. 10.u
Fig. 10.v
P4114S Rev 03
pRack PR300T +0300018EN rel. 1.5 - 02.05.2017
ENG
Advertisement
Chapters
Table of Contents
