Table of Contents
Advertisement
Usage
5.
6.
7.
4.8. Operation
The machine's functions can be controlled using the control panel -
see Figure 3-3 on page 12.
During operation, the operator pushes the grinder forward over the
floor surface.
4.8.1. Standby
To activate the machine's functions, turn the ON/OFF knob to the
right. When the knob is in this position, the green Standby light
(DUTY) is lit, indicating that the machine is in standby mode.
4.8.2. Emergency stop switch
The emergency stop switch, (EM-Stop) must only be used in an
emergency.
When the switch is pressed, all the electrically-powered equipment
on the machine is turned off.
Note!
Do not use the emergency stop switch to stop the machine ,other
than in emergencies, as it causes wear to the switch.
Note!
As long as the emergency stop switch (EM-Stop) is pressed in, the
machine cannot be started. Reset by turning the switch 45°, so it
pops out again. The machine can then be restarted.
4.8.3. Starting the machine
For a description of the control panel, see Figure 3-3 on page 12.
1.
22
Fill the tank with cold water.
Turn the tap on the left side of the machine to the open
position.
Turn the tap to the closed position once wet grinding is
finished.
Make sure the emergency stop switch is not activated.
HTC 500
1.0
Advertisement
Table of Contents
