Operation; Standby; Emergency Stop Switch - HTC 650 HDX User Manual

Usage
2.
3.
4.
Warning!
Only use cold water with no chemical additives.
5.
6.
7.

4.8. Operation

The machine's functions can be controlled using the control panel -
see Figure 3-3 on page 12.
During operation, the operator pushes the grinder forward over the
floor surface.

4.8.1. Standby

To activate the machine's functions, turn the key to the right. When
the key is in this position, the green Power light on the control
panel is lit, indicating that the machine is in standby mode.

4.8.2. Emergency stop switch

The emergency stop switch, (EM-Stop) must only be used in an
emergency.
When the switch is pressed, all the electrically-powered equipment
on the machine is turned off.
Note!
Do not use the emergency stop switch to stop the machine ,other
than in emergencies, as it causes wear to the switch.
24
Inspect the floor carefully and remove any protruding
objects, such as reinforcement rods or bolts, and any debris
that could otherwise get caught in the machine.
Attach the appropriate tool to the machine.
Set the handle to the working position, see Figure
4-2 on page 17.
Fill the tank with cold water.
Turn the tap on the left side of the machine to the open
position.
Turn the tap to the closed position once wet grinding is
finished.
HTC 650 HDX
1.0