Every Month (Or 100 Hours); Repairs; Spare Parts - HTC 500 Manual

Maintenance and repairs
•
•
Tip!
Recondition all the grinding holders at the same time.

5.5. Every month (or 100 hours)

•
•
•
•
•
•
•

5.6. Repairs

Any repairs that may be required must be carried out by a HTC
Service Centre, which has trained service personnel and uses
HTC original parts and accessories. Contact your retailer if your
machine requires servicing. For contact information, see Contact
Information at the start of the manual.

5.7. Spare parts

To ensure rapid delivery of spare parts, always specify the model,
the machine's serial number and the spare part number when
ordering. Information on the model and serial number can be found
on the machine's name plate.
26
Check the grinding holders. Remove the tools and run the
machine in mid air at the slowest speed. If the grinding
holders oscillate or wobble significantly, they are damaged.
Check that the upper belt is whole, by turning the large disc
in one direction or the other. If there is resistance the belt is
whole, if the disc rotates freely the belt is broken.
Tighten anything that may have vibrated loose.
Remove the grinding cover and check that it is undamaged.
Check the upper belt and replace if necessary.
Check the seals on the shafts on which the upper belt runs
and replace if necessary.
Scrape and vacuum-clean the parts shielded by the grinding
cover.
Test run and listen for any dissonance from the bearings.
Clean or, if necessary, replace the filter to the electrical
cabinet.
HTC 500
1.0