Table of Contents
Advertisement
DESCRIPTION
The MATCO TOOLS MP200STDVI is a dual input voltage, DC only, inverter stick welder with an
exceptionally smooth DC stick welding performance. It's intended for welding steel, stainless steel, cast
iron, and hard surfacing, using electrodes from 1/16 inch to 5/32 inch. This unit can also perform lift start
DC TIG welding on steel and stainless steel materials with the optional TIG Torch MATACTT2. Argon
shielding gas along with a regulator, gas hose, and TIG filler rod is also required for TIG welding. The
MATCO TOOLS MP200STDVI uses leading edge Inverter Technology to provide high quality welds that
are crisp, clean, and consistent with plenty of power and will impress the most experienced of welders.
The Inverter Technology is evident from the moment you take this unit out of the box. One of the many
advantages of inverter technology is creating more welding power from a smaller transformer. This unit is
intended to be used on a 50 amp 230V AC circuit or 120V, 20A AC circuit, without the use of an
extension cord. This unit is supplied with a NEMA Class 6-50P plug and will require a NEMA Class 6-50R
receptacle. Do not remove the power plug! Use the supplied 120V adapter when running off 120V power.
Power
Indicator
Alarm
Indicator
Digital Amperage
Welding Amperage
Display
Control
Process Selector
Negative Weld
Switch
Output Connector
Electrode
Holder And
Weld Cable
Positive Weld
Ground Cable
Output Connector
And Clamp
Page
7
of 22
1703116-12
Advertisement
Table of Contents
