Table of Contents
Advertisement
FREQ_LEVEL?
FREQ_TYPE?
FREQ_UNIT?
FUNC?
LOCKOUT
OUT?
PRES?
PULSE_CNT?
RTD_WIRE?
SIM?
TC_TYPE?
TEMP_UNIT?
TRIG?
TSENS_TYPE?
VAL?
ZERO_MEAS?
Sets the frequency and pulse amplitude
Returns the frequency and pulse amplitude
Set the frequency output to continuous (frequency) or pulse.
Returns frequency output type, continuous or pulse
Sets the unit for frequency and pulse
Returns the unit for frequency and pulse
Returns the current mode of the upper and lower display
Returns user to manual operation of the calibrator
Locks out the keypad of the calibrator, and allows for remote operation
only
Sets the mode for measuring on the lower display.
Sets the pressure unit on the lower display
Sets the output of the calibrator
Returns the output of the calibrator
Returns the model and serial number of the attached pressure module
Returns the pressure unit for the upper and lower display
Sets the number of pulses for the pulse train
Returns the number of pulses in the pulse train
Puts the calibrator in remote mode
Sets the number of wires used by the RTD mode.
Returns the wire number setting used in the RTD mode
Sets the output for mA simulation
Returns the output of the mA simulation
Sets the thermocouple type
Returns the thermocouple type
Sets input/output temperature unit for RTD and TC
Returns the temperature unit for RTD and TC
Starts and stops the pulse train in pulse mode
Returns TRIGGERED when a pulse train is on. Returns UNTRIGGERED
when the pulse train is off.
Sets temperature sensor type.
Returns temperature sensor type
Sets the measuring mode for the upper display.
Sets the upper pressure unit
Returns the measured values
Zeros the pressure module
Returns the zero offset of the pressure module
37
Advertisement
Chapters
Table of Contents
