Table of Contents
Advertisement
Maintenance
Liability
The manufacturer does not accept any liability for any
damage arising from the use of non-original parts and for
modifications, additions or conversions made without the
manufacturer's approval in writing.
Service paks
A Service Pak is a collection of parts to be used for a
specific maintenance task, e.g. after 50, after 500 and after
1000 running hours.
It guarantees that all necessary parts are replaced at the
same time keeping down time to a minimum.
The order number of the Service Paks are listed in the
Atlas Copco Parts List (ASL).
Use of service paks
Service Paks include all genuine parts needed for normal
maintenance of both compressor and engine.
Service Paks minimize downtime and keep your
maintenance budget low.
Order Service Paks at your local Atlas Copco dealer.
Service kits
A service kit is a collection of parts to fit a specific repair
or rebuilding task.
It guarantees that all necessary parts are replaced at the
same time which improves the uptime of the unit.
The order numbers of the Service Kits are listed in the
Atlas Copco Parts List (ASL).
Contact Atlas Copco.
Storage
Run the compressor regularly, e.g. twice a week, until
warm.
Load and unload the compressor a few times to operate the
unloading and regulating components. Close the air outlet
valves after stopping.
If the compressor is going to be stored
without running from time to time,
protective measures must be taken.
- 48 -
Safety precautions
Before performing any maintenance jobs
always put the battery switch in the "OFF"
position.
Always observe the applicable safety
precautions. See section Safety during
maintenance and repair.
Please note that when the battery switch is
off there can still be some parts live!
Unauthorised modifications can result in
injuries or machine damage.
Always keep the machine tidy to prevent
fire hazard.
Poor maintenance can void any warranty
claims.
Advertisement
Table of Contents
