Maintenance; Troubleshooting - RACCEWAY E-MOPED User Manual

MAINTENANCE

ATTENTION:
To carry out maintenance, first switch off the electric scooter and remove the ignition key.
Regular check:
Regularly check the condition of your electric scooter and make regular checks for proper tire
inflation, check the sensitivity of the brakes, tighten all components, and make sure they do not
make any unusual noise or abnormal noise when driving.
Brake adjustment:
Proper adjustment of the brakes will promote the correct operation of the warning lights and
increase driver safety:
The brakes are adjusted in a similar way to each norma I wheel. lt is important that the brakes work
properly and that the electrical disconnect devices are in working order (cable to the brake levers).
There is a micro-adjustable rear drum brake nut that allows you to very easily adjust the response of
the brakes to the push.
Once the brakes are set, turn the wheels to see if there is any chafing. Also make sure that if any of
the brakes is pressed, the power cut function will be activated and the motorwill stop.
Lubrication:
To ensure the long life of your electric scooter, the following components should be regularly
lubricated every 6 months:
Front axle; cha in; rear axle; the idle, front fork and other moving parts must be lubricated only with
grease and the brake must not be filled with grease at all.
Electrical components do not need to be specially cleaned as they have been lubricated at the
factory. lf any defect is found, contact an authorized service center.
Cleaning:
The electric scooter should be cleaned with a damp sponge, but care should be taken to avoid
electrical parts coming into contact with water (battery connection, engine (rear axle), electrical
cables, handlebar controls, etc.). Dry with a cloth.
Do not use a strong stream of water when cleaning the electric scooter. Use cloth to avoid short
circuiting electrical components. Your electric scooter is durable and does not require waxing. lf
necessary, clean with a mild detergent and rinse aid to restore its original shine.

TROUBLESHOOTING

PROBLEMS
lf you turn the switch to the ON position,
the battery indicator does not light. The
engine is not working, there is no power
to the electric scooter.
Battery connected. lf the throttle is
moved, the engine is not working ar its
maximum speed is limited.
The driving distance becomes shorter.
The charging indicator does not light up
when charging.
Other problems.
POSSIBLE CAUSES
The battery is completely discharged.
The battery connection cable is loose.
The fuse is blown.
The circuit breaker is in the OFF.
Battery charge too low.
Problem with the throttle.
The motor wiring is loose.
lnsufficient battery capacity.
Aging battery.
Tires are underinflated.
Frequent braking, uphill ar against the
wind driving.
The connection cable has come loose.
The fuse is blown.
The charger is damaged.
Problems with electrical components.
13
SOLUTIONS
Charge the battery.
Secure the cable.
Replace the fuse.
Set to ON.
Fully charge the battery.
Replace the throttle handle.
Contact service.
Fully charge the battery.
Replace the battery.
lnflate the tires.
Use pedals more often.
Secure the cable tightly.
Replace the fuse.
Replace the charger.
Contact an authorized service center.