Maintenance - RACCEWAY KOBRA User Manual

MAINTENANCE

Technological breakthroughs have made components more complex than ever before, and the
pace of innovation is increasing. This on-going revolution makes it impossible for this manual
to provide all the information required to properly repair and/or maintain your E-SCOOTER In
order to help minimize the chances of an accident and possible injury, it is critical that you
have all repair and maintenance work performed regularly.
For more detailed maintenance instructions or for ordering replacement parts please contact
your E-SCOOTER dealer. Local bicycle retail stores, which have service facilities in your area,
can also assist you with certain non-electrical repairs or adjustments that you are not qualified
to make or for which you do not have the specific or specialized tools needed for repair.
The fact that these vehicle have no combustion engine, no clutch, no ignition plugs, no
carburetor, and uses no gasoline means it requires basically no maintenance.
In generally all the regular mechanic maintenance is to:
- Adjust the brakes
- Check the nuts and bolts
- Check tire pressure
ATTENTION:
To carry out maintenance, first switch off the electric scooter and remove the ignition key.
Regular check:
Regularly check the condition of your electric scooter and make regular checks for proper tire
inflation, check the sensitivity of the brakes, tighten all components, and make sure they do
not make any unusual noise or abnormal noise when driving.
Brake adjustment:
Proper adjustment of the brakes will promote the correct operation of the warning lights and
increase driver safety:
The brakes are adjusted in a similar way to each norma I wheel. lt is important that the brakes
work properly and that the electrical disconnect devices are in working order (cable to the
brake levers). There is a micro-adjustable rear drum brake nut that allows you to very easily
adjust the response of the brakes to the push.
Once the brakes are set, turn the wheels to see if there is any chafing. Also make sure that if
any of the brakes is pressed, the power cut function will be activated and the motor will stop.
Lubrication:
To ensure the long life of your electric scooter, the following components should be regularly
lubricated every 6 months:
Front axle; cha in; rear axle; the i dle, front fork and other moving parts must be lubricated only
with grease and the brake must not be filled with grease at all.
Electrical components do not need to be specially cleaned as they have been lubricated at the
factory. lf any defect is found, contact an authorized service center.
- 22 -