Advertisement
Available languages
Available languages
CHARGING INSTRUCTIONS
• Use only the charger designed for this electric scooter (never use a charger from another model).
Before charging, set the switch to the OFF position and remove the key. Use the charger in a dry and
well-ventilated area.
• The charger is for indoor use only. Protect the charger from water to avoid short circuiting. Do not
use in wet, flammable, or explosive environments. Do not remove the plug by pulling the cord, always
grasp the charging port by the metal body.
• First, plug the charger's output plug securely into the battery receptacle, and then insert the input
plug into a power outlet. The charger indicator lights up to indicate that charging is in progress.
• When the light changes from red to green, it indicates that the battery is fully charged. Typically, it
will take approximately 6-1 O hours for the battery to fully charge. lf you have time, it is recommended
to charge it for 2 more hours after the indicator light turns green. (This will positively affect battery
life).
• When the green light is on, the charger is in a maintenance charging state. lf you are away for a long
time, you should remove the charger plug, especially in hot weather.
• The charger heats up du ring charging, so keep it away from heat. Always keep the charger dry and
clean. The electronics inside are under high voltage, so never disassemble it yourself.
• After charging, first unplug the power plug and then remove the output connector from the battery.
Do not leave the charger plugged into a battery or wall outlet for an extended period of time as this
may damage the charger and cause a fire.
• Keep the charger aut of the reach of children while charging. Do not place anything on the charger or
allow any liquid to come into contact with the charger.
• The first 10-15 charges are unstable, the charging time can be up to 12 hours, and the charge
indicator on the scooter display can show a partially discharged battery. After formatting the battery,
everything will be fine
• Furthermore, the battery is protected by its own fuse 30A, which is stored from the side of the
plastic battery pac k and secured with a plastic screw cap.
CHARGER
E-FICHTL can be charged:
1. Remove the battery from the step section, bring it to an electrical outlet and start charging.
2. Disconnect the battery in the step section from the power connector, connect the charger
and charge.
3. The E-FICHTL has, under the front seat, a connector for connecting the charger, when charging
however, the main circuit breaker in the seat section must be active.
There are 2 diodes on the charger, the first red lights up whenever the charger is in the mains, the
second signals charging. After connecting the charger for charging, the first red indicator light
comes on immediately and then the second, first green and then, when everything is OK, red. When
fully charged, it will glow green again.
10
Advertisement
