Installation Instruction - RACCEWAY E-MOPED User Manual

INSTALLATION INSTRUCTION

Each electric scooter was carefully assembled and inspected before leaving the factory. You have
to install the pedals and rear view mirrors. Follow the installation instructions. Tools Required:
Key; hex key; screwdriver, etc. Each package includes a set of installation tools.
1. UNPACKING THE E-MOPED
1. Remove the protective paper wrapper.
2. Unscrew the four side metal elips.
3. Cut the securing plastic tape from the structure.
4. Remove the front wheel from the frame.
5. Remove the securing wire at the bottom left.
6. Loosen and then s lide the shaft rod with the axle delimiting rollers out of the front fork.
This will release the E-MOPED from the metal structure.
7. Slide the E-MOPED out of the frame.
8. You will find a fixed package with a set of keys and a remote control on the surface
of the carrier holder.
9. Remove the packed case from the middle of the E-MOPED, in which you will find:
necessary screws for mounting, plastic covers, rechargeable battery, rear-view mirrors, pedals
and user manual.
4