Advertisement
Available languages
Available languages
7. INSTALLATION MIRROR
1. Screw the mirrors into the hole at the top of the handlebars.
2. After screwing in the mirrors, tighten the nut with wrench
3. Slide the free end of the rubber cover so that it covers the nut and aligns with the handlebars.
Warning: Before driving, adjust the mirrors so that you have a good view behind you.
8. CHARGING THE BATTERY
The battery can be charged in two ways„
First charging method:
1. Remove the battery from the step section, bring it to an electrical outlet and start charging.
Second charging method:
1. lnto the charging hole, which is located on the outside under the seat above the rear fender.
This external socket allows you to charge a locked motorcycle without unlocking or unfolding
the seat. The condition is that the circuit breaker is on.
9. SWITCHING THE ELECTRIC SCOOTER
1. Switch on the main circuit breaker of the electric scooter.
2. Then place the key in the ignition and turn it to the "on" position.
The electric scooter can also be switched on twice by pressing the remote control
(see the description of the remote control).
t::.
When standing for a long time, we recommend disconnecting the
battery or turning off the circuit breaker. Our machine is equipped
with an alarm with remote start and it has a constant consumption.
lt is therefore possible to discharge the batteries below the critical
limit du ring long-term standing.
8
Advertisement
