Enabling/Disabling The Automatic Power-Off Function; Turning The Backlight On Or Off; Selecting The Unit Of Measurement; Positioning The Product/Taking A Measurement - Parkside PWM A1 Operation And Safety Notes

˜ Enabling/disabling the automatic
power-off function
When the product is switched on, press and hold
for approx . 2 seconds to enable or disable the automatic
power-off function .
When the automatic power-off function is enabled,
is shown on the display
[ 8 ]
product switches off automatically if no button has been
pressed for approx . 20 minutes .
˜ Turning the backlight on or off
When the product is switched on, press and hold
for approx . 2 seconds to turn the backlight on or off .
˜ Selecting the unit of measurement
Press UNIT to enter the setting mode . SET
5 ] [
shown on the display
3 ] [
The wind speed unit m/s
This means, that this unit is selected .
Repeatedly press UNIT
available units .
When the desired unit flashes on the display
pressing UNIT . After 2 seconds, the selected unit is
5 ] [
saved automatically . The product returns to measurement
mode .
. In this case, the
[ 3 ]
is
13 ] [
.
flashes on the display
15 ] [
to toggle between the
5 ] [
, stop
3 ] [
˜ Positioning the product/Taking a
measurement
When the product is switched on, hold and position the
4 ] [
product so that the airflow to be measured enters the
vane from the rear side of the product .
[ 1 ]
For more accurate results, try to keep the axis of the
vane within 20° of the wind direction . The airflow being
measured must have direct and unhindered access to the
vane without any obstacles in between .
Wait for approx . 5 seconds . The display
wind speed together with the current temperature .
The display
[ 6 ]
temperature is higher than +50 °C (+122 °F) .
The display
temperature is lower than –10 °C (+14 °F) .
The display
speed exceeds 30 m/s (108 km/h, 5906 ft/min,
67 .2 mph, or 58 .32 knots) .
.
3 ] [
˜ Using the data hold function
(freeze)
In measurement mode, briefly press HOLD
the current readings on the display
H
shows
11 ] [
Press HOLD
H
goes off in the display
11 ] [
shows Hi when the measured
[ 3 ]
shows Lo when the measured
[ 3 ]
shows OL when the measured wind
[ 3 ]
. The display
3 ] [
.
again to return to measurement mode .
6 ] [
.
3 ] [
shows the
3 ] [
to freeze
6 ] [
GB 11