Table of Contents
Advertisement
125992691.qxd
26/05/2004
11:12
Operating Sequence
Before using your tumble dryer for the first time, we
recommend to place a few damp cloths inside the
appliance and dry for 30 minutes.
There may be dust inside a brand new tumble dryer.
Drying
1. Connect the appliance.
2. Open the door (see picture).
P1149
3. Load the items one at a time, shaking them out
loosely.
4. Close the door. Please check the laundry does not
get caught between the door and filter.
5. Select the drying programme or time. The lights
DRYING, COOLING and END come on. The
light of the START/PAUSE button flashes and the
display shows the duration of the programme.
6. If required, press the LOW TEMPERATURE
button and/or the NO BUZZER button or the
QUICK DRY button.
7. Select the DELAY START if required. The
selected delay appears on the display for 2
seconds, then the duration of the selected
programme is displayed.
8. Press the START/PAUSE button: the
corresponding light stops flashing and drying
starts. Only the DRYING light stays lit. If you
have selected the DELAY START, the machine
begins its countdown.
If the programme selector dial is turned to another
position, when the machine is running, the buzzer
will sound, the programme phase indicator lights
will flash and Err appears on the display.
The drum turns alternately in both directions
during drying.
All drying programmes end with a 10 minute
cooling phase (light COOLING is on).
You may remove the laundry after this phase.
The END, CLOGGED FILTERS and FULL
TANK lights illuminate. The display shows a
static zero and the buzzer sounds to indicate the
end of the cycle.
Pagina
9
P1108
9
9. If the laundry is not removed at the end of the
cycle, the dryer performs an anti-creasing phase
(duration: 30 minutes maximum).
If you do not remove the laundry, the dryer will
stop automatically at the end of the anti-creasing
phase.
The END, CLOGGED FILTERS and FULL
TANK lights remain lit and the buzzer sounds for
2 minutes.
The START/PAUSE button goes off and a
flashing zero appears on the display.
10.Turn the programme selector dial to "RESET/
OFF"; all the lights go out. The appliance is
switched off.
Remove the laundry.
If you open and then close the door before
turning the programme selector dial to
"RESET/OFF", all the lights corresponding to
the phases making up the performed
programme come on and the display shows the
duration of the programme.
After each use
• Clean the filters (see page 11).
• Empty the water reservoir (see page 12).
Important!
If the drying programme has to be stopped before it
reaches the end, we recommend that you turn the
programme selector dial to position "Cooling" and
wait until the end of this phase before removing the
laundry. This will avoid a build-up of heat inside the
appliance. To do this first turn the dial to "RESET/
OFF" and then to "Cooling" and depress
START/PAUSE Button .
Modifying the programme
To change a programme which is running, first cancel
it by turning the programme selector dial to "RESET/
OFF". Select the new programme and press the
START/PAUSE Button.
Advertisement
Table of Contents
