Bellfires UNICA-2 90 Instructions For Use & Manual Daily Maintenance page 18

Bellfi res
Pilot gas adjustment screw
(Factory set) (Puncture the casing
with a small screwdriver)
Figure 5: Gas regulating block
• Possible error messages:
* 3 seconds: short beeps, audible when the motor-knob operates:
Receiver batteries need changing soon (having heard this signal, the
appliance can be ignited another ten times approximately).
* 5 seconds: unbroken beeps:
Error. For example, one of the cables may not be properly connected.
Important: If the pilot fl ame goes out, then wait for
at least 5 minutes before repeating the
above procedure.
STAND-BY MODE (PILOT LIGHT)
AM
PM
ON
OFF
1 2
18
8-wire Receiver Jack
• Press button and hold to set appliance to
pilot light.
We recommend to let the pilot light
burn in the winter months, to prevent
condensation on the inside of the glass.
Adjustment screw
Maximum burner pressure
(Factory set and sealed)
Microswitch
Instructions for use
English
Motor-knob