Page 3
This manual is released by Vecow Co., Ltd. for reference purpose only. All product offerings and specifications are subject to change without prior notice. Vecow Co., Ltd. is under no legal commitment to the details of this document. Vecow shall not be liable for direct, indirect, special, incidental, or consequential damages arising out of the use of this document, the products, or any third party infringements, which may result from such use.
ECX-3600 PEG, ECX-3400 PEG, ECX-3200MX PEG, ECX-3200 PEG and ECX-3100 PEG. The ECX-3000 PEG packs a variety of LAN ports including 2.5G, 2.5G PoE+, 2.5G PoE+ with X-Coded M12 and GigE LAN, and supports high-speed data transfer up to 20G through USB 3.2 Gen 2x2. With up to 4 PCIe expansion slots, support for DDR5 4800MHz memory up to 64GB, the ECX-3000 PEG offers a robust combination of performance and flexibility to facilitate AIoT applications.
2.1 Packing List 2.1.1 ECX-3800 PEG Packing List Item Description ECX-3800 PEG AI Computing System (According to the configuration of you order, the ECX-3000 PEG series may contain SSD/HDD and DDR5 SO-DIMM. Please verify these items if necessary.) Item Description...
2.1.2 ECX-3600 PEG Packing List Item Description ECX-3600 PEG AI Computing System (According to the configuration of you order, the ECX-3000 PEG series may contain SSD/HDD and DDR5 SO-DIMM. Please verify these items if necessary.) Item Description Outlook Usage P head_...
2.1.3 ECX-3400 PEG Packing List Item Description ECX-3400 PEG AI Computing System (According to the configuration of you order, the ECX-3000 PEG series may contain SSD/HDD and DDR5 SO-DIMM. Please verify these items if necessary.) Item Description Outlook Usage P head_...
2.1.5 ECX-3200 PEG Packing List Item Description ECX-3200 PEG AI Computing System (According to the configuration of you order, the ECX-3000 PEG series may contain SSD/HDD and DDR5 SO-DIMM. Please verify these items if necessary.) Item Description Outlook Usage P head_...
2.1.6 ECX-3100 PEG Packing List Item Description ECX-3100 PEG AI Computing System (According to the configuration of you order, the ECX-3000 PEG series may contain SSD/HDD and DDR5 SO-DIMM. Please verify these items if necessary.) Item Description Outlook Usage P head_...
2.2 Front Panel I/O Functions In Vecow ECX-3000 PEG series family, all I/O connectors are located on front panel and rear panel. Most of the general connections to computer device, such as USB, LAN Jack, USB TYPE-C, HDMI, DVI-I, Display Port and any additional storage, are placed on the front panel.
Page 36
There are 4 USB 3.2 connections available supporting up to 10Gb per second data rate in the front side of ECX-3000 PEG series. It also compliant with the requirements of Super Speed (SS), high speed (HS), full speed (FS) and low speed (LS).
Page 56
2.4.4 SATA1 to SATA4: SATA III Connector There are 4 onboard high performance Serial ATA III (SATA III) on ECX-3000 PEG. It supports higher storage capacity with less cabling effort and smaller required space. The pin assignments of SATA1 to SATA4 are listed in the following table :...
The built-in MCU monitors the ignition signal and turns on/off the system according to pre-defined on/off delay period. 2.6.1 Adjust Ignition Control Modes ECX-3000 PEG provides 16 modes of different power on/off delay periods adjustable via SW2 switch. The default rotary switch is set to 0 in ATX/AT power mode.
Page 79
Note : 1. DC power source and IGN share the same ground. 2. ECX-3000 PEG supports 12V to 50V wide range DC power input in ATX/AT mode. In Ignition mode, the input voltage is fixed to 12V/24V for car battery scenario.
APPENDIX B : Software Functions B.1 Driver API Guide In Header folder, Vecow.h and VecowLinux.h contain usabled API for Windows/Linux. BOOL initial_SIO(BYTE Isolate_Type, BYTE DIO_NPN) Initial machine for IO and watch dogtimer. Isolate_Type : DIO type. 1 : Isolated DIO;...
Page 148
C.6 To Create RAID Volume on"Rapid Storage Technology" Software ECX-3000 PEG is featured with two SATA HDD’s for RAID volume, so there are two options to choose on this page. Let’s take RAID 1 as an example, select ”RAID 1”.
Need help?
Do you have a question about the ECX-3000 PEG and is the answer not in the manual?
Questions and answers