Table of Contents
Advertisement
7. Slide the Right Inside Upright Cover (70) against
the lower end of the right Upright (83). Press
the Right Outside Upright Cover (71) against
the Right Inside Upright Cover until it snaps into
place. Make sure that the wires (F) are not
pinched.
Attach the Left Inside Upright Cover (not
shown) and the Left Outside Upright Cover
(not shown) in the same way. Note: There is
not a wire on the left side.
8. Press the two tabs on the Tablet Holder (65) into
the slots (G) in the console assembly (D).
Attach the Tablet Holder (65) with four #8 x 5/8"
Machine Screws (8). Note: Start the two top
Machine Screws À rst, and then start the two
bottom Machine Screws. Be careful not to
overtighten the Machine Screws.
IMPORTANT: The Tablet Holder (65) is
designed for use with most full-size tablets.
Do not place any other electronic device or
object in the Tablet Holder.
7
70
8
Start First
8
12
83
F
71
65
D
G
Advertisement
Table of Contents
